38
Audio Design Associates
www.ada-usa.com
To Set the Matrix Coefficient Parameter
1. Make sure that Pro Logic II Music or custom 1-3 mode is selected on the main display.
2. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
3. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
4. Press the Mode knob. The display will change to the Pro Setup menu.
5. Rotate the Mode knob until the cursor flashes over the P in PL. Press the Mode knob.
6. The display will change to the speaker level menu with the cursor flashing over the P in PL 1.
7. Rotate the Mode knob until the cursor flashes over the M in MATRIX COEF.
8. Rotate the Input knob to increase the center width from 0 to 3 in increments of 1.
Surround Delay Setting
The delay parameter allows you to turn on and off the electronic delay for the surround channels.
When set to on, the surround channels are delayed according to the value set in the Pro Setup menu.
To Set the Surround Delay Parameter
1. Make sure that Pro Logic II Music or custom 1-3 mode is selected on the main display.
2. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
3. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
4. Press the Mode knob. The display will change to the Pro Setup menu.
5. Rotate the Mode knob until the cursor flashes over the P in PL. Press the Mode knob.
6. The display will change to the speaker level menu with the cursor flashing over the P in PL 1.
7. Rotate the Mode knob until the cursor flashes over the D in DELAY .
8. Rotate the Input knob to turn on and off the surround channel delay.
Dimension Setting
The dimension parameter allows you adjust the balance from the front channels to the rear channels.
You can adjust the dimension parameter in increments of 1 from 0 to 8.
To Set the Dimension Parameter
1. Make sure that Pro Logic II Music or custom 1-3 mode is selected on the main display.
2. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
3. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
4. Press the Mode knob. The display will change to the Pro Setup menu.
5. Rotate the Mode knob until the cursor flashes over the P in PL. Press the Mode knob.
6. The display will change to the speaker level menu with the cursor flashing over the P in PL 1.
7. Rotate the Mode knob until the cursor flashes over the D in DIMEN .
8. Rotate the Input knob to change the balance from the front channels toward the rear channels.
Storing Pro Logic II Custom Settings into Memory
Once you have made all the desired parameter changes to Pro Logic II, you can store custom modes
into memory for recall. The four memory presets available for recall are: PLM, PL1, PL2, and PL3.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales